These instructions are for a fully assembled P3 payload with the DJI M300 and M350. Before this you should have followed the full set up instructions on our support site or youtube.

Take off check list:

• Unpack M300, attach legs and unfold arms ensuring these are locked tightly.
• Ensure all firmware is up to date. You can check the latest supported firmware here
• Attach P3 to the M300 turning the sky port until its in the lock position.
• Make sure that the P3 is balanced in all directions (when balanced the camera will stay in any position)

• When balancing ensure the lens cap is off and the card is formatted and inserted.
• Power on the controller
• Power on the UAV. (This should initialize the P3)
• Wait for the camera to connect (This can take up to 30 seconds, you can also check the status lights - Full status light set here)

            Light should be as follows

           1) Green

           2) Blue

           3) Green

• HDMI box should show flashing blue.
• Now you should be ready to fly!

            As always if you have any issues you can contact support!